AnitaSqwimbex said:
You could snip the wires at each end of the box and connect them back directly.
What they said above!
You can also use crimp connectors or soldering, or even electrical tape if you’re feeling brave.
@Olivia
If all else fails, I’ll definitely go this route. Thanks for the advice!
Julius said:
@Olivia
If all else fails, I’ll definitely go this route. Thanks for the advice!
It might still fail—looks like you have a button that resets when power is cut, not an actual on/off switch. The button just sends a signal to the circuit board to turn the light on, so it won’t stay on after losing power. To keep it always on, you’d need a proper switch, like mentioned earlier.
Does this box plug directly into the wall, or is there an AC/DC converter involved?
sonvilla said:
Does this box plug directly into the wall, or is there an AC/DC converter involved?
It’s a 2-prong cable that plugs into what looks like a waterproof outdoor box.
Is this for a strand of LED lights or something? That wire looks really thin.
Jason said:
Is this for a strand of LED lights or something? That wire looks really thin.
Yes, it’s for a Christmas decoration.
Jason said:
Is this for a strand of LED lights or something? That wire looks really thin.
Yes, it’s for a Christmas decoration.
And this runs on wall power, right? Not battery or USB? As someone else suggested, if you plug it into a smart outlet, set it on, then power off and wait a bit before powering it back on, it might keep the setting. Once we can see the insides, it might be clearer.
Is this for one of those giant ceramic Christmas trees from the craft store? My wife got one and I’m thinking about trying the snip-and-bypass method too…
Yep, that’s it.